AUTHOR Alarm IGLA 200, Quick Start Manual

Page: 9 / 16

7
IGLA SYSTEM SETTING
Change the PIN-code
The PIN-code set in the service centre shall be
changed when the car-owner get his/her car back
from the service centre with the anti-theft system
IGLA installed.
Also it is recommended to change the PIN-code if you
suspect someone has watched you entering the PIN-
code.
1. Switch on the ignition without starting the engine.
2. Enter the current PIN-code to authorize. There will
be 2 indication signals.
3. Press the accelerator pedal* as far as it can go and
keep it pressed.
4. Enter the current PIN-code once again. The device
will pass to the PIN-code change mode and the
indication signals will start flashing every 3 seconds.
Release the accelerator pedal*.
If the current PIN-code includes «Slight touch on
accelerator pedal», after the authorization (item 2)
it is necessary to enter the PIN-code once again and
then press the accelerator pedal as far as it can go
and keep it pressed until indication appear. Then
perform item 5.
5. Enter the new PIN-code using the buttons available
for programming**.
Every click will be followed by
the indication signal .
* For some car model other controls are used instead of an accelerator pedal
(visit http://author-alarm.com).
** See the annex at http://author-alarm.com.
!
!