1. Find the wall stud nearest to and on the right side of the power supply
wiring using a wall stud finder.
2. Draw a vertical line of approximately 20" (50 cm) in line with the wall stud
at the approximate height of your mounting.
2. Attach the wall dock to the mounting location by screwing
two M6 x 50 screws (B) into the lower mounting holes.
Tighten the screws using the screwdriver type PH2.
1. Drill two 5/16" holes and insert two 5/16" diameter wall
plugs into the lower mounting holes.
1
2
Remove the covers from the charger by removing the
screws using the screwdriver type T10.
Mounting the Wall Dock
7
Place the wall dock with the center holes aligned with the vertical line.
Mark the two lower mounting holes (A) and remove the wall dock.
Wall
B
B
B
Wall
A
A
Preparing for Installation
Placement
