AUTEC LK NEO 6, Instruction Manual, Page: 32 / 48

8.11.4 Procedure to modify the PIN code
If a PIN code is needed for the Transmitting Unit, it can be modified to limit the use of the
Radio Remote Control.
To modify the PIN code, perform the following procedure with the Transmitting Unit switched
off and the STOP pushbutton released.
1. Press pushbuttons FUNCTION and START and hold them down until the green LED
blinks (1 blink per second).
2. Activate the commands of the PIN code sequence provided in the Technical Data Sheet.
3. Activate command S1 (see Technical Data Sheet) repeatedly until LED 2 illuminates.
4. Activate command S2 (see Technical Data Sheet) to confirm your selection (green LED
blinks twice per second). You can choose the 3 commands you want to set as PIN code
amongst all the commands on the Unit. If you want to start the Radio Remote Control with:
-
a single-command PIN code: press the START pushbutton as PIN 1 and PIN 3;
-
two-command PIN code: press the START pushbutton as PIN 1 or PIN 3.
5. Activate the command you want to allocate as PIN 1 (LED 1 and green LED are steady on).
6. Activate the command you want to allocate as PIN 2 (LED 2 and green LED are steady on).
7. Activate the command you want to allocate as PIN 3 (LED 3 and green LED are steady
on). PIN code is saved automatically.
8.12 Command activation
When the Radio Remote Control is started, it is possible to activate movements, functions
and commands on the Machine by acting on the related pushbuttons or switches, whose
functions and symbols are decided by the Manufacturer and/or the Installer. To identify the
relation between the actuators and the corresponding Machine movements, the Machine
Manufacturer and/or the Installer shall provide relevant instructions and the User shall be
properly trained.
8.13 Radio link interruption
When the radio link is incorrect or interrupted, the automatic stop function activates (see
paragraph "Control devices" in the Instruction Manual's general part).
The green LED of the Transmitting Unit signals this interruption by switching from slow blinking
to one of the following statuses (see chapter 11):
-
fast blink;
-
on with steady light;
-
two blinks and a pause;
-
three blinks and a pause.
8.14 Transmitting Unit automatic switch off
The Transmitting Unit automatically switches off when:
-
the battery is flat (see paragraph 8.14.1),
-
the Radio Remote Control is not used for a certain time (see paragraph 8.14.2).
To start the Radio Remote Control, see paragraph 8.11.
32
LIULK6N03_eng-00
General operating instructions
AUTEC - AIR SERIES