AUTEC LK NEO 6, Instruction Manual, Page: 28 / 48

8.7.4 Indication of the battery charge level in the LK NEO 6 and LK NEO 8 Transmitting
Unit (Model LKN Type LA1CM)
Perform the following procedure to check the charge level of the battery in the LK NEO 6
and LK NEO 8 Transmitting Units:
1. switch off the Transmitting Unit and unlock the STOP pushbutton,
2. activate command S1 (check in the Technical Data Sheet which actuator it corresponds
to) and press the START pushbutton until LED 1, LED 2 and LED 3 (indicating battery
level) illuminate:
-
1 LED on: low level
-
2 LEDs on: medium level.
-
3 LEDs on: maximum level.
The charge level indication disappears after some seconds.
Commands associated to the actuators that are activated during the procedure
to check the battery charge level are not sent to the Machine.
8.8 ID internal tx memory
The "ID internal tx memory" is a key containing the address that is used to code messages
exchanged between the Transmitting Unit and the Receiving Unit.
This key, if present, is inside the Transmitting Unit.
LK NEO 6 and LK NEO 8 (Model LKN Type LA1CM)
S/N:
XXXXXXX
S/N:
XXXXXXX
S/N:
XXXXXXX
A
LK NEO 6 DF (Model LKN Type DA1DM)
S/N:
XXXXXXX
S/N:
XXXXXXX
S/N:
XXXXXXX
A
A ID internal tx memory
A ID internal tx memory
When the Transmitting Unit does not have the"Key ID 0-1" (see paragraph 8.1.2), the
Technical Data Sheet shows if an "ID internal tx memory" is present (DIP switch 2 is set in
the ON position).
28
LIULK6N03_eng-00
General operating instructions
AUTEC - AIR SERIES