5
7.
Ensure guard and mud flap are in position and in good condition.
8.
Operator to work inside appropriately screened excavator, never
stand or operate saw in the same plane as the blade and always
stand at a safe distance from the saw (minimum 30m).
9.
Rock saw to be checked every hour and after use for damage or lose
bolts.
10.
Only use approved AUSTRAMAC blade designed for material being
cut and the correct size for the rock saw (do not cut metal unless it is
imbedded in concrete).
11.
Operator to observe blade at all times while cutting, if circular
scratches are observed on boundary wall, or blade begins to wobble
cease cutting immediately and check bolts.
12.
Never use a blade that is out of tension.
13.
Keep saw well clear of excavator and other persons.
14.
Once the cut is complete slowly raise the saw so that only
approximately 100mm of blade is in the cut. Turn off oil and allow
blade to stop in cut. Remove saw from cut and place on stand.
15.
Always turn off machine and remove key when getting out
of the excavator or performing any maintenance or inspection.
16.
Never apply lubricants or anti cease to bolts.
Transport Handling and Storage:
It is essential that the rock saw is transported in a safe manner to ensure
the safety of other and that the machine is not damaged.
AUSTRAMAC supplied a stand and strap for the purpose of
transportation. The rock saw has a tag indicating the weight of the rock
saw and blade. The tag also indicates the weight of the saw, blade and
stand combined. Operators are responsible for ensuring that they safely
transport the rock saw. The rock saw is delivered fully assembled and
ready for use. Operators should consult AUSTRAMAC for guidance on
any repairs or maintenance.
Summary of Contents for FLASHCUT 1400 RM
Page 14: ...14 ...
