AUSTRAMAC FLASHCUT 1400 RM, Operator'S Manual, Page: 8 / 14

8
e. No more than two segments in a row missing on the blade and
no more than 4 in total are missing.
f. Adequate cutting time left on blade (minimum 3mm).
g. Blade bolts are tightened to
120Nm and flange bolts to140Nm
.
5.
Operator to warm up hydraulic fluid, ensure hydraulic fluid in
excavator is free of contamination and complete test run prior
to cutting.
Use
Inappropriate use of the rock saw may cause serious injury or death. It is
essential that operators follow the instructions for use and that they follow
the instructions provided at the handover of the machine. Operators
should also consult the operator’s manual for the excavator license. The
following job steps and safety precautions outline the requirements for
safe suit of the rock saw.
•
Secure work site
1. Ensure worksite is secure and signposted at all times.
2. No persons to enter 30m exclusion zone.
3. Persons to never stand in the same plane as the cutting blade.
4. Ensure guard is in appropriate position at all times.
5. Operators must hold appropriate license for excavator.
6. Induction to be completed with all operators prior to
commencement.
•
Plan for cut
1. Site controller to discuss cut with operator and plan procedure.
2. Services inspection to be completed prior to cut (Dial before you
dig).
3. Operator to inspect site for all hazards including overhead wires,
structures, hazards slopes, trenches or slippery surfaces.
4. Warn all other workers in vicinity of works being completed.