AUSTINDRIVE Assembly Tutorial Rev 3.02
December, 2020
22
WIRE THE ENCLOSURE
NOTE: For simplicity, not every wire is shown in these assembly diagrams, and the enclosure in
the photos does not have a graphic on it.
Wires are not drawn here with the correct lengths. Keeping the wires long while you build
allows you to remove the circuit board to make circuit changes easier.
Install the two input/output jacks
as shown, solder lugs up.
NOTE: Be careful when using pliers to tighten the nuts.
One slip, and you can scratch the enclosure. On my website, you can download and 3D print
FREE plastic sockets
(“TurnUps”)
that I designed specifically for this project.
•
Yellow wire to switch Pin 8
•
Green wire to switch Pin 2
With the exterior nuts tightened, use a small dab
of Nail Polish to secure the nut to the thread. Nail
Polish acts like removeable glue, and reduces the
chance of the nuts loosening, with vibration and
use. Alternately, you can wait and do this for
all
the connectors at the very end.
Check-Off
Summary of Contents for AUSTINDRIVE
Page 1: ...AUSTINDRIVE Assembly Tutorial Rev 3 02 December 2020 1 AUSTINDRIVE PEDAL DIY PROJECTS ...
Page 6: ...AUSTINDRIVE Assembly Tutorial Rev 3 02 December 2020 6 Theory of Operation 4 ...
Page 32: ...AUSTINDRIVE Assembly Tutorial Rev 3 02 December 2020 32 x x 4001 4001 ...
Page 33: ...AUSTINDRIVE Assembly Tutorial Rev 3 02 December 2020 33 4001 4001 ...
