YL-250 5000KG 2 BASE PLATE CAR HOIST
Installation and operation manual
33
TO RAISE LIFT
• Read operating and safety manuals before using lift.
• Always lift a vehicle according to the manufacturers recommended
lifting points.
• Position vehicle between posts.
• Adjust swing arms so that the vehicle is positioned with the center
of gravity midway between pads.
• Use truck adapters as needed. Never exceed 9” of pad height.
• NEVER use lift pad assemblies without rubber slip over pads
in place.
• Raise the vehicle by depressing button until the vehicle just lifts off
the ground. Re-check to make sure the vehicle is secure and all
locking pins are lock in place.
• Raise vehicle to desired height. Lower vehicle onto nearest safety.
• Always ensure safeties are engaged before any attempt is made to
work on or near vehicle.
TO LOWER THE LIFT
• First raise the lift clear to the safeties.
• Release safeties by pulling on the safety handle..
• Be sure tool trays, stands or personnel are cleared from under
the vehicle.
• Lower vehicle by activating lowering handle on power unit.
• Before removing vehicle from lift; position lift arms and supports
to provide an unobstructed exit.
• NEVER, drive over lift arms.
REQUIRED MONTHLY MAINTENANCE
• Check all arm adjusting locks for proper operation.
• Check all cables connections, bolts and pins to ensure proper
mounting and torque.
• Visually inspect safeties for proper operation.
• Lubricate posts with grease.
• Inspect all anchors bolts and retighten if necessary.
• Check all posts for squareness and plumb.
• Inspect all pivot arms pins making sure they are properly secure.
• Check equalizer cable tension, and adjust if necessary.
• If lift is equipped with overhead micro switch, check for
proper operation.
1. WARNING:
If cement anchor bolts are loose or any component of
the lift is found to be defective
DO NOT USE THE LIFT
.
2. Never operate the lift with any person or equipment below
the vehicle.
3. Never exceed the rated lift capacity.
4. Always ensure the safeties are engaged before any attempt is
made to work on or near the vehicle.
5. Never leave lift in elevated position unless the safeties
are engaged.
6. Do not permit electric motor to get wet! Motor damage caused by
dampness is not covered under warranty
WARNING
WARNING
NEVER LIFT ANY VEHICLE IN ANY MANNER WITH LESS THAN ALL
FOUR (4) ARMS. RATED CAPACITY OF EACH LIFT ARM IS NO GREATER
THAN ONE FOURTH (1/4) OF THE OVERALL LIFT CAPACITY.
HIGH-LIFT