Cylinder
Retainer Clip
Cylinder
Carry Handle
To avoid pinching, keep fingers and hands near
corners of Cylinder Retainer Clip when
swinging Clip over cylinder.
4) Swing the Cylinder Retainer Clip over round
shoulder of the LP cylinder. Exert pressure at
ends of clip until it stops at the cylinder
carrying handle.
Cylinder
Retainer Clip
Rotate
Cylinder
14
FIG. 13A
3) Lift and swing LP Cylinder Retainer Clip to
outside of grill. Set LP cylinder in the large
hole inside the Bottom Shelf. Rotate the LP
cylinder toward the front of grill so regulator
hose may connect. (FIG. 13A)
FIG. 13B
5) Remove the protective cap from the LP
cylinder valve. (Fig. 13C) (Save cap for
re-capping.) Make sure all control Knobs are
turned “OFF”. Route the hose outside and
under crossbrace. Hold Regulator in a
straight line with LP cylinder valve so the
connection does not cross thread. Insert
Regulator Nipple into the LP cylinder valve.
Hand tighten coupling nut in clockwise
direction. Do not use tools.
Disconnecting LP gas cylinder:
1) Turn all control knobs to the “off” position
and turn the handle on the LP gas cylinder
clockwise until it stops.
2) Turn coupling nut on regulator counter-clock-
wise until regulator is released from the
threaded LP cylinder gas nozzle.
3) Replace the protective cap over LP cylinder
gas nozzle.
To reduce the risk of serious bodily injury or death:
· This installation must conform with local codes or, in
the absence of local codes, with either the National
Fuel Gas Code, ANSI Z223.1/NFPA 54 Natural Gas and
Propane Installation Code, CSA B149.1, or Propane
Storage and Handling Code, B149.2 or the Standard for
Recreational Vehicles, ANSI A 119.2/NFPA 1192 and CSA
Z240 RV Series, recreational Vehicle Code, as
applicable.
· If an external electrical source is utilized, the outdoor
cooking appliance, when installed, must be electrically
grounded in accordance with local codes or, in the
absence of local codes, with the National Electrical
Codes, ANSI/NFPA 70, or the Canadian Electrical Code
CSA C22.1.
· Keep any electrical supply cord away from any heated
surfaces.
BEFORE USING YOUR LP GAS GRILL
INSTALLATION CODES
Hand tighten coupling
nut in clockwise direction
FIG. 13C
Remove
Protective Cap
Make sure hose is
routed outside and
under crossbrace.
