5) Use a pipe cleaner to clear insect nests from the inlet
hole of main burner
(FIG. 20C
) and side burner ventilation
hole.
(FIG. 20D)
Open up the main burner holes and the
side burner holes with a small nail or wire.Normal wear
and corrosion may enlarge some holes, however, if large
cracks or holes are found, replace the Burner. Use a
brass wire brush to remove food particles and corrosion
from the burner surfaces. (Note: It is normal for surface
rust to be present on the burners.) It can be wire brushed
and coated with cooking oil periodically. Verify that there
are no insects or insect nests blocking the inlet hole.
6) Check the Side Burner electrode to see if it is loose.
(FIG. 20D)
If so, tighten the Side Burner Wingnut
underneath to maintain 3/16” gap between electrode tip
and side burner. Note: Before next step you may wish to
clean the rest of the Grill Bowl inside.
(See Grill Body
and Cart Cleaning.)
7) If grill is to be stored, coat Burner lightly with cooking oil
and wrap in a protective cover to keep insects out.
8) After cleaning, re-install the Burner. Be sure that it is
positioned correctly. The valves should fit inside the
venturi ends of the burner.
(See FIG. 20A)
9) Re-attach Heat Shield to bottom of Bowl and Side
Crossbrace.
10) Check burner operation after re-assembly.
11) Replace Grease Cup, Flame Diffuser and Cooking Grid.
Clean Burner holes all around with small nail or wire.
Inlet holes
20
Heat Shield
Valve nozzles must fit inside
Burner venturi tubes .
FIG. 20A
FIG. 20C
To reduce the risk of a fire beneath the grill:
· Inspect and clean burner/venturi tubes for insects and
insect nests.
· Be sure burners are re-installed properly before using
grill.
·Inspect burners periodically, i
f large cracks or holes are
found, replace the Burner.
How to Clean the Burners:
1) Make sure the LP cylinder grill control knobs are turned
OFF and the grill is completely cooled.
2) Carefully remove Drip Cup, Cooking Grid and Flame
Diffuser.
3) Remove the Heat Shield under the bottom of grill Bowl by
removing the two screws
(FIG. 20A)
then the two screws
and wingnuts securing the Heat Shield to the Left
Sidebrace.
(FIG. 20B)
Just let the Heat shield hang on the
Drip Cup holder. Leave side burner in place.
4) Remove the two Burner screws from the bottom of grill
Bowl.
(FIG. 20A)
Lift Burner out from the top of the grill.
FIG. 20B
Wingnuts
Heat Shield
edge over
Crossbrace
edge
Screws
Heat Shield
Heat Shield Screws
Burner Screw
Burner Screw
FIG. 20D
3/16”
Clean Burner holes all
around with small
nail or wire.
