background image

 

IMPORTANT: THIS APPLIANCE MUST BE INSTALLED AND SERVICED BY A LICENSED ELECTRICIAN  
IMPORTANT: PLEASE READ FULLY PRIOR TO INSTALLATION OR OPERATION 

  This canopy rangehood is an indoor appliance and has been manufactured and tested to comply with 

Australian Standard/New Zealand AS/NZS60335.2.31:2004 inc amendment 1 & 2 with Electrical Approval 
Number ITACS A/10752EA. 

  This canopy rangehood is for domestic use only and not for commercial use. 

  Always switch power off prior to installing, servicing or cleaning the appliance. 

  Never use the appliance without filters. 

  Please read the notes on maintenance / cleaning, especially the filters. 

  Exhaust air must not be discharged into a heating flue or wall cavity, unless the cavity is designed for that 

purpose. 

  If the rangehood is to be installed in an area that also has gas, oil or coal fired heaters, the area must be 

well ventilated to prevent a partial vacuum in the room. This includes gas hobs. (A partial vacuum in the 
room could result in too high a concentration of gas in the atmosphere and excessive consumption of 
oxygen). 

  The appliance is supplied with an approved power cable which must not be changed. If the supply cord of 

this equipment is damaged, it must only be replaced by the manufacturer, its service agent or similarly 
qualified person in order to avoid hazard. 

  Care and attention should always be taken when cooking with oils, alcohol, etc; which give off flammable 

vapours. Pre-used oil is especially dangerous in this respect. Do not use any uncovered electrical grill with 
this rangehood. 

  To avoid possible risks of fire always comply with the maintenance instruction below. 

 
 

ATTENTION: THIS APPLIANCE MUST BE EARTHED 

When making the electrical connection, check that the socket has an earth connection and that the voltage 
values correspond to those indicated on the rating plate inside the appliance. The power socket connection is 
to be easily accessible after installation. 

 
 

WARNING: FOR YOUR SAFETY 

  This appliance is not intended for use by young children or infirm persons without supervision. 

  Children should be supervised to ensure that they do not play with the appliance. 

  There should be adequate ventilation of the room when the rangehood is used at the same time with 

appliances burning gas or other fuels. 

  You must read the details concerning the method and frequency of cleaning. 

  There is a fire risk if cleaning is not carried out in accordance with the instructions. 

  Do not flambé (pour alcohol over food and set fire to it during cooking) under the rangehood. 

  Exhaust air must not be discharged into an existing flue which is used for exhausting fumes from 

appliances burning gas or other fuels. 

  Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air 

is fulfilled. 

 
 

INSTALLATION 
Notes 

  Prior to installation. Please ensure that any existing or proposed roof ducting installation for connection to 

this appliance is suitable and complies with local municipal building codes and other statutory/ building 
regulations. If you are unsure, please check with appropriate authorities or a qualified roof ducting installer. 

  This appliance must be installed in accordance with any local municipal building codes and other statutory 

regulations. 

  Attention should be given to ensure that any applicable regulations concerning the discharge of exhaust air 

is fulfilled.  

  Ensure that the fully installed canopy has the clearance of 650 mm to 700mm between the lowest part of 

the hood and the cooking hob.  

  Before drilling any holes check the wall and ceiling are clear of any electrical cables, pipes etc. 

Summary of Contents for CS900








Reviews: