4
ENGLISH
5
ENGLISH
OPERATION
Control Switch
Using the switch located on the unit, select one of the following settings by sliding the switch either left
or right.
(FIGURE 2)
ON:
This setting allows the shredder to be automatically started by inserting
paper into the shred opening. Always feed the paper in as straight as
possible. Paper feeds from both left and right sides. When the paper
has passed through, the shredder will automatically stop.* (FIGURE 2)
REVERSE:
In the unlikely event of a paper jam, the reverse setting can be used
to help clear the cutters of paper that has not passed through. Never
attempt to clear a jam by using the reverse function until you have
emptied the wastebasket. (FIGURE 2)
FORWARD:
The forward setting can also be used to help clear the cutters in the
event of a paper jam.
This allows to manually activate the shredder into cutting mode.
(FIGURE 2)
CONTINUED NEXT PAGE
INSTALLATION
Paper Shredder
Operating Instructions
Installation
Operation
Maintenance
Troubleshooting
Service Center
Limited Warranty
* ONE FOLDED SHEET OF PAPER EQUATES TO 2 SHEETS OF PAPER
Heavier paper, humidity or other than rated voltage may reduce shredding capacity.
1. Make sure the basket door is securely closed shut. This shredder features a safety power cut off and
will not operate if door is open. Shredders with pull-out wastebaskets feature a safety power cut off
upon bin removal. The supplied wastebasket activates this switch, which allows the shredder to be
operable. (FIGURE 1)
2. A socket-outlet should be near the equipment and be easily accessible.
3. Connect the power cord to any standard 120 volt AC outlet.
Crosscut shredders have very sharp exposed blades on the underside.
Use care when mounting the shredder on the wastebasket.
FIGURE 2
!
Caution:
R
F
FIGURE 1
Sheet Capacity
Paper Shred Size
Paper Entry Width
Credit Card / CD Capacity
Duty Cycle
Voltage
16 Sheets of 20 lb. bond paper*
0.16 in. x 0.98 in. pieces
4 mm x 25 mm pieces
8.7 in / 220 mm
1 at a time
20 min. on / 50 min. off
120V~60Hz / 4.0 A