OPERATOR MANUAL
SECOND EDITION
4/2015
Maintenance
• Disconnect power by pulling power cord plug from wall outlet.
• To clean the exterior, wipe the surface with a soft cloth. If the surface is very dirty, use a
neutral detergent, then wipe again with a soft cloth.
CAUTION:
• Never put water directly on the surface of the shredder.
• Never clean the case with benzene or thinner, since it will cause discoloration.
• Do not dismantle the shredder. Contact your Formax Dealer for service.
Safety Devices and Other Features
Automatic Reverse Rotation
When too much paper is inserted, the cutter stops operating and
automatically rotates in reverse to discharge the jammed paper.
The shredder will beep. Reduce the amount of paper and restart the
operation.
Door Switch
If the door is open, the shredder will not operate.
Automatic Stop
When the waste bin is full, the “FULL” LED will light and the cutter stops
operation. Open the door, remove the waste bin and empty. Replace
the waste bin, close the door, and press START to resume operation.
Automatic Power Shut-Off
If the shredder operates continuously for more than 30 minutes, the
power is automatically shut off.
If the motor is overloaded, the “STOP” LED will flash until it cools down.
When the flashing stops the shredder is ready to be used again.
•
Do not allow children to use the machine.
•
Do not operate with a damaged power cord or plug, or when the machine is damaged
in any manner.
•
Unplug the shredder when it is being moved, or if it is not in use for an extended
period of time.
•
Do not disconnect the power by pulling only the cord. Hold the plug when
disconnecting.
•
Keep the shredder away from direct sunlight.
•
Do not sit on the shredder or place anything on top of it.
•
Never open the fixed switch or cover.
Safety Precautions, continued
FD 8650HS High-Security w/AutoOiler
Cross-Cut Paper Shredder
NSA Approved:
Meets the requirements of NSA/CSS specification
for Level 6 High-Security cross-cut shredders.
