Network Interface
The WACI NX has two 10/100 Auto MDX Ethernet ports. LAN1 is POE (Power Over Ethernet) capable.
The Auto MDX allows the use of null or straight through LAN cables to the ports.
LAN Port
The WACI may be connected to a network using a standard RJ-45 Ethernet cable in this port. Both 10Mb
and 100Mb connections are supported.
Port
RJ-45
1
TX+
2
TX-
3
RX+
4
NC
5
NC
6
RX-
7
NC
8
NC
LED Indicators
The green LED on the LAN port indicates that a network has been detected.
The yellow LED on the LAN port indicates that data is being transmitted or received through the port.
Relays
The Relays on the NX-22 have two connection types: N.O. = Normally Open and N.C. = Normally
Closed. The “Normal” position is the state of the relay when it is not turned on (not energized). You can
turn the relays on and off using the relay diagnostic page (see Relay Diagnostics, page
), using an
Event Manager “Relay Action” (see Relay, page
), or through an RPC method call (see Relay Methods,
).
Relay Ports 1&2
Each port consists of 3 lines: NO (Normally Open), CP (Center Pole), NC (Normally Closed). Connect
the incoming wire to the CP connection, and the outgoing wire to either of the other two ports (NO or
NC). The outgoing port you choose depends on which type of connection you wish to consider “Normal”.
LED Indicators for Relay Ports 1&2
Two red LEDs indicate activity for each Relay Port.
Summary of Contents for WACI NX-22
Page 36: ......
Page 53: ...Finally drag and drop selected files from your File Explorer...
