VIII. Quick Start
STEP 1: Powering Up
Locate the power adapter that came with your WACI. Plug the small end into the power supply port
(labeled “Power”) on the lower left side on the back of the WACI, and the large plug into a wall socket or
compatible power supply.
You should observe the following behavior in this order:
•
Once power is applied the green Power LED will immediately light as well as the LCD
backlight. It will remain lit while the WACI is plugged in. All other LEDs will be off and the
LCD will have a message “Initializing”.
•
The WACI will run through its internal hardware diagnostics.
•
After approximately 5-10 seconds (assuming the self-test passes), on the LCD will display
firmware version and current IP addresses for the LAN ports. If a LAN port is set to DHCP it
may take longer as it will try to get an IP address from the DHCP server. Static IP addresses
will allow the WACI NX to boot within 10 sec.
Summary of Contents for WACI NX-22
Page 36: ......
Page 53: ...Finally drag and drop selected files from your File Explorer...
