AURATON S03 RTH, User Manual

Page: 17 / 24

17
Temperature setting
NOTE: The first time any function button is pressed, the illumination
is always switched on first and only then the button's function is
activated.
In order to set the temperature in the
normal operation mode:
1. Press the or button.
The segment that shows the
temperature goes into the edition
mode and starts blinking.
[plus] [minus]
Switching the controller on for the first time
After the batteries are properly
installed in the battery compartment,
the LCD display shows all segments for
one second (a display test) and then it
shows the software version.
After a moment, the current
temperature in the room is displayed.
Then the controller is ready for
operation.
16
RESET - Deregistering all devices paired with
the receiver
In order to deregister all devices paired with the
receiver, simultaneously press both the pairing
and the deregistering button ( and ) and hold
them for at least 5 seconds until the LED flashes
alternating red and green. Then release both
buttons.
A properly completed process of deregistering all
devices is signalled after approx. 2 seconds by
the LED colour changing to green and then
switching it off for a short period of time.
LED
NOTE : If after executing the RESET function the RTH receiver is disconnected
from power supply and then connected again, the receiver will automatically
enter “pairing” mode for 120 seconds. A newly purchased RTH receiver
without any factory-paired devices (i.e. not the one bundled with the
regulator) will behave the same way.
Signalling operation and reception of data packet
Each radio transmission received by the AURATON RTH receiver from the
paired device is signalled by a temporary change of LED colour to orange.
Switching on the relay is signalled by the LED lit red, whereas switching it off is
signalled by the LED lit green.