Aura LM-270, Manual

Page: 8 / 30

ASSEMBLY
This metal cutting bandsaw is completely assembled, just
needs to assemble the machine stand.
Assembling the machine stand
Join the left part, right part to bottom plate with 6-hex
head screws M8x16 w/6- 8mm washers.
Attach the H-shelf to assembled parts with 4--hex head
screws M8x16 w/4- 8mm washers.
Attach the V-shelf to assembled parts with 5--hex head
screws M6x12 w/10- 6mm washers, 5-hex nuts M6.
Attach the door frame w/door and fasten it with 4-hex
head screws M8x16 w/8-8mm washer, 4-hex nuts M8.
Mount the Coolant system assembly to bottom plate
with 2-Hex head screws M8x16 w/2-8mm washer.
Assemble the loose parts and accessories
Fit the components supplied:
Mount bar stop rod.
Mount and align the roll-supporting arm as per the
counter-vice table.
Dis activation of machine
Carefully lift the saw head onto base, and fasten the
If the machine is to be out of use for a long period, it is
machine head by 6-Hex head screw M10x20, and washer
advisable to proceed as follows:
10mm.
Detach the plug from the electric supply panel,
Loosen blade,
Release the saw arm return spring,
Lowing the saw arm as possible,
Empty the coolant tank,
Carefully clean and grease the machine,
If necessary, cover the machine.
l
Check the condition and suitability of the equipment
available.
l
Do not touch the suspended loads and remain at a
safe distance from them.
Before starting to lift the machine make sure that all
movable parts have been securely fastened.
Ensure that the crane
'
s lifting capacity is suitable for the
machine. Lift the machine carefully and move it slowly,
avoiding bumps or sudden movements.
l
The lifting and transporting operations can be
extremely dangerous if not carried out with maximum
caution.
l
Move all unqualified personnel away from the area.
Clean, clear and close off the installation area.
Fig 1
7
Fig 2