Aura LM-270, Manual

Page: 13 / 30

12
Always assemble blades having dimensions
specified in this manual and for which the blade
guide heads have been set.
This metal cutting bandsaw can not accept thick
than 0.9mm blade.
Adjusting the blade to the flywheel
Loosen the hex screws ( Q1,Q2,Q3 ).
Use an allen wrench on set screw ( R ) to adjust the tilt
of the flywheel.
Turning the set screw clockwise will tilt flywheel so
that the blade will ride closer to the flange
.
Turning the set screw counter-clockwise will tilt
flywheel so that the blade will ride away from the
flange
.
After the adjustment is finished fasten the hex
screw in this order: Q3, Q2, Q1 .
Checking the adjustment of the blade
Use a strip of scrap paper and slide it between the
blade and the flywheel while it is running.
if the paper is cut then the blade is riding too close to
the flange. Re-adjust.
if you notice that the blade is riding away from the
flange
.
Then re-adjust.
Always assemble blades having dimensions
specified in this manual and for which the blade
guide heads have been set
.
Fig 18
Fig 16
Fig 17
Fig 19