Problem
Problem
Problem
Problem
R
R
R
Reason
eason
eason
easonssss
M
M
M
Method
ethod
ethod
ethodssss
Control
panel
have
no
electricity
Power is off or “emergency”button down
Check the power and emergency
button
Fuse tube broken
Check and replace insurance pipe
Don’t turn
Force between rollers too large
Lift a little the upper roller
Friction is too large
Adjust friction
Motor key loosen or fall off
Tighten sprocket key
Motor or speed knob get problem
Contact with motor or governor
Laminated paper isn't clear
and have white point
Roller temperature is not enough
Increase roller temperature
Dust on the paper
Clean the dust
Film quality not good
Contact suppliers to replace film
laminated paper have
pleated bubbles
Roller’s force is not uniform or too much
Adjust roller force
Paper not flat
Put paper in 90 angle into rubber
roller
Speed slow and temperature too high
Increase speed and reduce temperature
Press-paper roller not in the right position
Press-paper roller fully touch paper
Laminated paper continuous
running aslant
Roller force is not evenly on both sides
Adjust the roller force
Paper at first not straight
Make the paper straight
Film fold
Film tension is too small
Adjust material-roller’s resistance
The upper roller's temperature too low
Adjust to the required temperature
laminated
paper
curly
seriously
Film's tension is excessive
Adjust to suitable tension
The winding tension is too large
Adjust to suitable tension
