3. Put the tube into roller and set rubber mat on the tube, tighten it and the racks with
screws
1. Porcelain cap
2. Porcelain pipe
3. Hex nuts
4. Flat mat
5. Wire
Step
Step
Step
Step two:
two:
two:
two: Wire
Wire
Wire
Wire IIIInstallation(such
nstallation(such
nstallation(such
nstallation(such as
as
as
as above)
above)
above)
above)
1. After the tube installed well and take off the porcelain cap, porcelain pipe, hex nut,
flat mat from the both sides of the tube.
2. Put wires on the tube.
3. Put the unloaded flat mat, hex nuts, porcelain pipe, porcelain cap pack to the tube.
Note:
Note:
Note:
Note: The
The
The
The hex
hex
hex
hex nuts
nuts
nuts
nuts must
must
must
must be
be
be
be tighten!
tighten!
tighten!
tighten! If
If
If
If loose
loose
loose
loose,,,, will
will
will
will appear
appear
appear
appear electric
electric
electric
electric spark
spark
spark
spark ,,,, the
the
the
the power
power
power
power
will
will
will
will increase
increase
increase
increase to
to
to
to broken
broken
broken
broken wire
wire
wire
wire and
and
and
and other
other
other
other components.
components.
components.
components.
6. Force Adjustment
The degree of parallelism of the rollers can directly affect the laminating quality and
the picture running direction, the roller parallelism has been adjust well before the
machine sending out,
but after a period of time, it still needs to adjust.
Note: the distance between the two rollers should be adjusted when the machine
working,
Pls check and adjust according to the following steps:
Left-side
Right-side
screw
screw
