ADVANCED MANUAL / bit Ten D /
43
7.
Before starting the
bit Ten D
update, the software will present the following warnings:
-
do not disconnect the
bit Ten D
from the PC;
-
do not disconnect the
bit Ten D
from power supply;
-
temporarily disable the PC stand-by and energy saving features;
-
temporarily disable the PC screen saver;
-
close all running applications;
-
temporarily disable anti-virus and anti-spyware systems.
8.
Once you have clicked
OK
, the Firmware update starts. The updating
process will last from 30 seconds to 1 minute with the green progress
bar showing correct advancement.
WARNING
: During the updating process the progress bar could stop
for few seconds. Do not interrupt the process in any way.
.
9.
Once the update has been successfully completed, the window on the
right will appear. To use the
bit Ten D
again, you have to exit the PC software
and the
bit Ten D
will turn off.
10.
Start the
bit Ten D
again and launch the PC software in
TARGET
mode.
If the
bit Ten D
firmware update has completed correctly, the dialog
box will show the following indications:
-
new
bit Ten D
firmware version.
11.
Repeat the
bit Ten D
calibration procedure
(see 7.1 - 8.1)
.
9
