ADVANCED MANUAL / bit Ten D /
32
If you click on the
Config
tab, a drop-down menu appears listing the entries shown in the
image on the right:
1.
I/O Configuration Wizard:
sets up the system and puts the
bit Ten D
in the required
conditions
(see 8.1.5)
.
2.
Working Mode - Standard Expert
: the software can work in two modes, acting on the
crossover filter.
• Standard:
simplified mode with some restrictions easing the use of the software
(see 8.10)
.
• Expert:
does not have any restrictions in the use of the software
(see 8.10)
.
We suggest to try and use the software in
Expert
mode; if it is too difficult,
change to
Standard
mode.
3.
Current Input Type:
shows the specialization assigned to the MASTER inputs.
4.
Start up/Shutdown delays:
allows you to change the
bit Ten D
turn on / off time settings.
•
StartUp Time:
is the delay between turning the device on and audio output. Every
amplifier exhibits, while turning on, its own delay before being
operational. If you set Startup Time to a value greater than or equal to
the longest of these delays, the entire audio system will be synchronized.
•
Shutdown time:
is the delay between turning the REMOTE OUT signal off for the
amplifiers and turning the bit Ten D off. It is generally not necessary to change this
parameter, but can be decreased if your amplifiers produce a “Bump” when shut down.
5.
Mute In / Phone Mute settings:
allows you to specialize the “
MUTE IN / PHONE MUTE
”
terminals (default settings) for the AUX and OPTICAL input to be automatically selected.
If you choose to use the “MUTE IN” terminal, it will be active if you apply + 12V to it.
If you choose to use the “PHONE MUTE” terminal, instead, it will be active if you apply
GND to it. According to the chosen setting modification, the corresponding default
function will be disabled.
6.
External source:
provides the ability to enable or disable auxiliary sources selected or
left out of the I/O configuration Wizard
(see 8.1.4)
.
7.
Help:
activating it by clicking on “
Active
”, it allows to display the context messages
regarding the software section in use. Different languages connected to the context
messages can be selected from a drop-down menu.
WARNING:
When you change from one mode to the other, the filters are restored to
their defaults.
1
2
3
4
5
6
7
8
8.6
“CONFIG” MAIN MENU
3
