Enter the transmitter program mode:
1. Turn the ignition switch to the “ON” position.
2. Within 10 seconds, press and release the valet/program switch
three times.
(Siren emits 1 short chirp indicating channel 1 has been entered)
3. Within 10 Seconds, Press and hold the ARM or ARM/DISARM
button of the first transmitter you wish to remain stored into the
control unit until a single chirp is heard from the siren.
(Repeat this for each transmitter you wish to remain stored in the
control unit).
The receiver stores up to four transmitters. To be certain all transmitter
slots in the receiver are occupied with transmitters you wish to con-
tinue to use and all others are erased, you will have to fill all four re-
ceiver slots. If in step 3 you identified one transmitter, you will have to
fill the additional 3 slots. If in step 3 you identified two transmitters, you
will have to fill the additional two slots, etc...
4. Press and hold any unused button or combination of buttons until a
long chirp is heard from the siren. Release and press the button or
button combination again and again until all remaining slots are
full.
Repeat this procedure with the appropriate transmitter buttons for all
other receiver channels.
R E P R I O R I T I Z I N G A T R A N S M I T T E R ’ S
PROGRAMMING:
To reprogram a receiver channel with a differ-
ent transmitter button once a code has been
stored, there will be two options:
1. Enter the transmitter program mode of the
receiver channel to be reprogrammed. Us-
ing any unused button or combination of but-
tons, push out the stored code by pressing
the unused button until a long chirp is heard,
then repeat 3 additional times. After this,
you can add any desired unused transmit-
ter button. This action erases only that par-
ticular receiver channel, all other codes will
remain stored.
4
800-225-6074
FCC ID ELVA------
APS2K4MS
PhilipsScrew
