22
Note
·
The display symbol
shows if the preamplifier output is activated.
·
If the option
Headphones only
is selected, the pre amplifier out-
put
PRE OUT
7 will be automatically disabled.
7.5 Set Autostart
Push the
set
key five times for less than two seconds to get to the
Autostart option. Push the
up
key on the front panel to activate the
Autostart function. If you like to deactivate the Autostart function push
the
down
key.
disabled
The Autostart function is disabled. After switching on the
mains switch 10 on the back panel, the SAM G2 enters
the stand-by mode. You have to use the
power
key on the
front panel or keys
Power On
or
Power Toggle
on
the Audionet System Remote Control
Harmony One
to
switch on the unit into normal operating mode
*)
.
active
The Autostart function is active. As soon as you connect
the SAM G2 to mains (i.e. use the mains switch 10 on
the back panel) the unit starts up automatically to normal
operating mode. Use this setting for timer controlled op-
erations.
7.6 Edit Channel Name
You can assign a fully user-definable name up to 14 characters in length
to each of the six input channels. Push the
set
key on the front panel six
times. The display will then show the number of the currently selected
input channel and the assigned channel name. The cursor in the display
marks the character you now may alter.
Use the keys
up
and
down
on the front panel to select the desired charac-
ter. Hold
set
key down for longer than two seconds to move the cursor
one step to the right. After the last position the cursor wraps around and
starts at the first position again.
*)
or switched on/off by Activities on the Audionet System Remote Control; see separate user's
manual
Harmony One
