14
face upwards. Now screw the ring of the plug onto the EPS input
jack 20 .
3. Connect both (!!) units (PRE1 G3 and EPS) to mains.
4. First, switch on the EPS on its back panel. Then switch on the
PRE1 G3 with the mains switch 1 .
5. Use the
power
key on the front panel or the keys
Power On
or
Power Toggle
*)
of the Audionet System Remote Control
Har-
mony One
to switch on the PRE1 G3. The PRE1 G3 is now ready
to use and gets its power from the external power supply EPS.
6. To switch off the PRE1 G3 into stand-by mode, use the
power
key on the front panel or keys
Power Off
or
Power Toggle
*)
of the Audionet System Remote Control
Harmony One
.
Important
·
Never switch on or off the EPS on its back panel while the
PRE1 G3 is operating.
·
For further information referring to the external power supply EPS
please consult its user's manual.
Tip
·
Use a high quality cable (for example the Audionet APC) to connect
the EPS to mains. The sound will improve.
5.8 Trigger output
Use trigger output
TRIGGER
3 to control (e.g. switch on/off) non-
Audionet devices. If you switch on the PRE1 G3 from stand-by mode, the
trigger ouput 3 provides a signal of 12 Volts DC. If you power down the
unit to stand-by mode, the signal of the trigger output 3 will be 0 Volts.
Tip
·
Use a 3.5 mm telephone mono plug to connect a device to the trigger
output 3 of your PRE1 G3. The pinning is as follows:
*)
or switched on/off by Activities on the Audionet System Remote Control; see separate user's
manual
Harmony One
12 Volt DC
Ground
Summary of Contents for PREI G3
Page 1: ...1 Stereo Pre Amplifier User s Manual ...
Page 2: ...2 ...
