12
Tip
·
The pinning of the balanced (XLR) input 16 and output 5 is
printed right beside the connectors.
5.3 Recording devices
You can connect up to two recording devices or effect processors to the
PRE1 G3 for recording and playback.
Connect the recording devices (like DAT or tape recorder) to the re-
cording output
REC OUT
9 of the PRE1 G3. For playback please con-
nect your recording devices only to input no. 5
IN 5
12 of the PRE1 G3.
if they are also connected to the output
REC OUT
9 of your PRE1 G3.
If you select input no. 5
IN 5
12 the output
REC OUT
9 is switched off
to prevent any feedback loops between your recording device and the
PRE1 G3.
Please use inputs no. 1 16 to no. 4 13 and no. 6 11 to connect sources
you like to record from. With these inputs the recording output
REC OUT
9 is always active
5.4 Monitor
The monitor loop of the PRE1 G3 makes it possible to insert a recording
device (for read after write verify) or an effects processor (e.g. surround
decoders) into the signal path.
Connect monitor output
MONITOR OUT
8 of the PRE1 G3 to the in-
put of the unit you would like to insert. Also, connect the output of the
unit to the monitor input
MONITOR IN
17 of the PRE1 G3.
For further information on how to use the monitor loop please refer to
section '
Set Monitor
' on page 23.
5.5 Phono
The PRE1 G3 can be upgraded with a phono pre amplifier. In this case
use input no. 6
IN 6
11 marked
PHONO
to connect your turn table to
the PRE1 G3. Connect the earth wire of your turn table to the earth con-
nector
GND
2 right beside input no. 6. For further information on the
optional phono module please refer to its user's manual.
Summary of Contents for PREI G3
Page 1: ...1 Stereo Pre Amplifier User s Manual ...
Page 2: ...2 ...
