30
7.2
Changing the batteries
In order to exchange the batteries of your Audionet Metal Remote Con-
trol
RC 2
, first you have to remove the six Phillips head screws on the
bottom side.
The battery compartment is to the left side of the circuit board. You need
two batteries type 'AAA' or 'Micro' with a voltage of 1.5V.
Important
·
While inserting the batteries please mind their orientation. The cor-
rect orientation is printed onto the bottom of the battery compart-
ment.
7.3
Settings for Audionet DNC
Important
·
The Audionet Metal Remote Control
RC 2
is configured to control
the DNC by factory default. You do not have to perform any addi-
tional configurations. For the sake of completeness, the following
section explains the correct setup for the DNC.
Depending on their type, Audionet (pre-) amplifiers use different system
addresses for their remote control code. A DIP switch on the circuit board
of the Audionet Metal Remote Control
RC 2
selects the desired system
address.
In order to set the system address you first have to open up the remote
control (see section '
Changing the batteries
' on page 30).
Battery compartment
