19
and the unit enters stand-by mode.
Note
·
Of course, you may switch on/off the DNC with the Audionet Metal
Remote Control
RC 2
. For detailed information please refer to section
"7 - Audionet Metal Remote Control RC 2" on page 28
.
6.1.3 Mains phase detection
The correct polarization of mains is important for reasons of audio clarity
and stability. Please align the mains cord so that the hot pin of the wall
outlet is connected to the pin marked
phase
3 of the mains input 2 on
the back panel. The DNC recognizes the incorrect polarization of the
mains plug automatically. Right after switching on the unit from stand-by
mode by pressing the
power
key on the front panel the following mes-
sage will appear in the display in case the mains polarization is incorrect:
If you got the above message, switch off the unit by pressing the
power
key. Please wait until the display no longer reads:
Disconnect the DNC from mains by operating the mains switch 1 . Now
pull the mains plug and re-insert it into the mains socket rotated by 180°.
If you switch on the unit again, the warning should not appear now.
Important
·
If the DNC issues the mains polarization warning or no warning at all
for both positions of the mains plug, check the connection to earth of
your mains socket and mains cord.
You have to ensure a stable
Going to sleep ...
►
Attention:
◄
►
Mains phase incorrect
◄
Going to sleep ...
