P. 14
AUDIOLAB Live 24 XL -
English version
DCA set
Meters
Talkback
36. DCA Groups1-12
Press this button to activate
the DCA level adjustment function. Slide the
corresponding fader to adjust the level of
the pre-defined DCA group. If it has not been
DCA grouped, the screen will prompt "This
DCA group is not defined".
37. RTA
RTA: Real-Time Analysis. Press this button
to activate the RTA function. With 31 frequency
points analysis, each frequency corresponds to
a level value, the level of each frequency can be
seen on the screen in real time.
38. GEQ
Press this button to activate GEQ func-
tion (note: only for output channel). In GEQ
page you can set the 31-band EQ. The win-
dow is as below. For the detail operation,
please refer to introduction of DSP Control
section.
39. Select Main
It is used for selecting Main
channel. Enter main channel interface by
pressing this button.
40. USB Lamp Connector
This connector can
connect with a 5V-500mA lamp which can
help you use the digital mixer whether in
dark situation or not conveniently.
41. LED Level Indicator
It indicates the level of
the MAIN channel or SOLO channel. By de-
fault, it is used to indicate the MAIN channel
level when the SOLO METER button is not
pressed.
42. Solo Meters
When the button is off, meters
above it indicate input level of main, while
illuminated indicate input level of Solo.
43. PFL
The default setting for the Solo bus is
After-Fader Listen (AFL); by pressing PFL,
Pre-Fader Listen is enabled. In either mode,
press Solo on any channel or bus to route
that channel to the Solo bus and has no ef-
fect on the main.
