TheDirector
Model D3400 • Model D4400
Installer’s Guide
®
11
Internet
Connectivity and
Control
Operation Tab
The first page you see when connecting to The Director
the first time via a web browser will be the Operations page.
The functionality and controls on this page are described
below:
Groups:
Grouping allows for channels to be grouped for
control via telnet for simple efficient operations. The telnet
commands are listed on page 15. Grouping allows for quick
control over the on/off and signal source states of each
group.
Standby:
The standby on/off buttons control the state of each
individual channel – whether the channel is on or not.
Signal Source:
Specifies where each channel pair is getting
it’s input source.
Trim:
Trim the levels of the input – in addition to the physi
-
cal gain adjustments on the back of the amplifier.
Temperature:
Provides status of channel temperature
Protection:
Shows channel protection status
At the top of the page, you can check the
line voltage, the global on/off state of the
unit (good place to check if you aren’t getting
audio), whether signal sense is engaged, and
note the number of logs. The log count is also
a link to a pop up page which will describe
the most recent events.
If you are not able to control signal sense
or turn The Director on or off, check the rear
of the unit to see if one of the switches there
is over-riding these controls or if the Ethernet
control is bypassed.
Note:
The rear panel switch for a
zone must be in “Bus 1/Net” position
for Ethernet switching of sources.
