AudioControl LC6i, User Manual

Page: 15 / 32

-----------------------------------------------15 ----------------------------------------------
Installing Your LC6i
By this time we are sure that you are chomping at the bit to install your
LC6i. Up to this point, everything you have read has served to educate
you on the operations of LC6i. Therefore if you are still with us, we
recommend you read the following sections very carefully.
Placement and Mounting of the LC6i
Your LC6i can be physically installed in numerous locations like behind
your dashboard, under a seat, or even in the trunk/boot. Since you will
be connecting to the speaker wires from the factory source unit or its
amplifier(s), you should select a location that is convenient for wiring.
Once you have selected a permanent mounting location, position the
unit and mark the appropriate mounting holes with a felt-tip pin or
scratch awl.
Before doing anything else, make sure you are not about to drill
a hole in a gas tank or pierce any existing wiring, fuel lines, or
hydraulic pipes. Nothing ruins your day more than an expensive
repair bill or massive fireball.
Drill a few small pilot holes and secure the chassis of the LC6i with
self-tapping screws.