-----------------------------------------------12 ----------------------------------------------
9. Pre-Amp Outputs:
These RCA connectors should be connected
to the next component after the LC6i, such as a signal processor,
crossover or amplifier. Do not connect any speakers directly to
your LC6i. (Definitely don’t connect to any home appliances, like
your microwave.)
10. Level Controls:
These knobs allow you to adjust the signal level
from your source unit to match that of your aftermarket ampli-
fiers. Because they are amplified, most factory-installed source
units have relatively high signal voltage output, which will require
you to decrease the signal level.
11. Channel Summed Indicators:
Under the cover of your LC6i are
jumpers that will allow you to sum selected channels into the
main channels. This is especially useful for factory-installed sys-
tems with actively crossed-over speaker systems. These handy
indicator LEDs let you know which channels are being summed
into the main inputs.
Figure 3:
Inside view
AutoMode
GTO
Jumper Settings
SUM CH3
SUM CH2
Summed
Separate
GND
Isolated
200
Ω
Ground
Isolation
TM
Disabled
Enabled
Summary of Contents for LC6i
