®
28
n
avIgatIng
tHe
s
etup
M
enus
INSTALL TIP
*
C
onCert
avr
-
8 /
avr
-
6
Dolby Prologic II Music Mode Settings
These setting apply to all two-channel inputs when PLII or PLIIx Music
mode is selected.
Dimension -
Adjusts the depth of the front/rear sound stage. For
normal listening this should be set to +3. Setting options are –3 to
+3 with default setting being “0”.
Center Width -
Determines how strongly the Pro Logic II decoder
processing creates the center channel image. Normally this signal
is fed only to the center channel speaker output, but if the center
speaker is set to “None” in the speaker setup, a phantom center
channel is created using the front left and right channels. Normally
this setting is left at +3.
Panorama -
When the Panorama Mode is enabled, the front center
image is extended to include the rear surround speakers. This pro-
vides a more enveloping wrap-around effect.
Digital Output Frequency -
Sets the sampling frequency of the audio Ana-
logue-to-Digital converter. Settings options are 44.1/ 48 /96 kHz. Default is
96 kHz
Maximum Volume -
Limits the highest volume that the Concert AVR-
6 / AVR-8 will play. This is useful if you have speakers or amplifiers with
limited power handling abilities.
Max On Volume -
This is the highest volume that the Concert AVR-6
/ AVR-8 will play when it is first switched on. This prevents the Concert
AVR-6 / AVR-8 from being turned on at shock volume levels from the last
time you were watching a good movie.
Display On Time -
This sets the amount of time the display is lit after a
command has been initiated. The options are: 5 seconds, 10 seconds, 30
seconds, 1 minute, Always On
CEC Control -
Enables the HDMI CEC control for one of the two HDMI
outputs. CEC set to enabled is required if ARC is desired in the system
configuration. Options are: Off, Output 1 or Output 2
ARC Control -
Enables the Audio Return Channel of HDMI 1.4. When
enabled and the display is properly configured, Audio will be retruned to
the AVR-6 / AVR-8 via the Display input. ARC Control depends on the
CEC Control to be enabled as well.
HDMI Audio to TV -
Enables the audio from the AVR-6 / AVR-8 to be
sent to the TV for listening to the TV speakers.
