CHAPTER 6 Hardware Maintenance
MP-1288 | Hardware Installation Manual
Figure 6-8:
Removing 50-Pin Telco Connector
d.
On the rear panel, remove all the hex-standoff screws securing the FXS blade to the
chassis, using a 3/16-in. hex-head nut driver. Each FXS port has two hex-standoff
screws (7 mm) on either side and therefore, you need to remove all six screws:
Figure 6-9:
Removing Hex Standoff Screws on Rear Panel (Example FXS Blade S4)
e.
On the front panel, remove the Fan Tray cover and Fan Tray module, as described in
f.
On the front panel, loosen the two Philips-head, spring-loaded captive screws located
on either side of the FXS blade:
- 44 -
