AudioCodes MediaPack MP-118, Installation Manual

Page: 51 / 58

Version 6.0 51 March 2010
Installation Manual 3. Configuring the Device
Note: At this stage, you can quit the Software Update Wizard, by clicking Cancel
4. Click the
, without requiring a device reset. However, once you start uploading a
cmp file, the process must be completed with a device reset.
Browse button, navigate to the cmp file, and then click Send File ; the cmp
5. Click one of the following buttons:
file is loaded to the device and you're notified as to a successful loading.
•
Reset ; the device resets with the newly loaded cmp,
•
utilizing the existing
configuration and auxiliary files.
Next ; the 'Load an ini
Note that as you progress by clicking
File' wizard page opens.
Next
6. In the 'Load an
, the relevant file name corresponding to the
applicable Wizard page is highlighted in the file list on the left.
ini
•
Click
File' page, you can now choose to either:
Browse , navigate to the ini file, and then click Send File ; the ini
•
Use the
file is
loaded to the device and you're notified as to a successful loading.
ini file currently used by the device, by not selecting an ini
•
Return the device's configuration settings to factory defaults, by not selecting an
file and by
ensuring that the 'Use existing configuration' check box is marked (default).
ini
7. You can now choose to either:
file and by clearing the 'Use existing configuration' check box.
•
Click Reset ; the device resets, utilizing the new cmp and ini
•
Click
file you loaded up to
now as well as utilizing the other auxiliary files.
Back ; the 'Load a cmp
•
Click
file' page is opened again.
Next
8. For loading the auxiliary files, follow the same procedure as for loading the
; the next page opens for loading the next consecutive auxiliary file
listed in the Wizard.
ini
9. In the 'FINISH' page, complete the upgrade process by clicking
file (Step
6).
Reset;
Figure 3-11: End Process Wizard Page
the device
'burns' the newly loaded files to flash memory and then resets the device. After the
device resets, the 'End Process' screen appears displaying the burned configuration
files (refer to the figure below).