AudioCodes 420HD, Administrator'S Manual

Page: 49 / 146

Administrator's Manual 3. Manual Configuration of a Single IP Phone
Version 2.0.11 49 400HD Series IP Phone with Microsoft Lync
3.3.2 Configuring Dialing
This section shows how to configure Dialing parameters. Only the parameters documented
in this section are applicable.
3.3.2.1 Configuring Automatic Dialing
This section shows how to configure Automatic Dialing using the Web interface or the
Configuration File.
¾
To activate automatic dialing using the Web interface:
1. Open the Dialing page (Configuration tab > Voice Over IP menu > Dialing).
Figure 3-17: Web Interface - Dialing - Automatic Dialing
2. Configure the Automatic Dialing section parameters using the table below as
reference, and then click Submit.
¾
To activate automatic dialing using the Configuration File:
„ Open the Configuration File page (Management tab > Manual Update >
Configuration File) and configure the parameters using the table below as reference.
Table 3-11: Automatic Dialing Parameters
Parameter Description
Activate
[voip/dialing/auto_dialing/enabled]
Determines whether automatic dialing is enabled (i.e.,
phone number is automatically dialed when you
off-hook the phone).
ƒ
[0] Disable (default)
ƒ [1] Enable
Timeout
[voip/dialing/auto_dialing/timeout]
Only displayed if the 'Activate' parameter is configured
to Enable. Defines the timeout (in seconds) before
automatic dialing occurs after the phone is off-hooked.
When set to 0, automatic dialing is performed
immediately.
ƒ
The valid range is 0 to 120. The default value is
15.
Destination Phone Number
[voip/dialing/auto_dialing/destination]
Only displayed if the 'Activate' parameter is configured
to Enable. Defines a number that will be automatically
dialed when the phone is off-hooked.
The valid value can be up to 32 characters.
http://arttel.ru
http://arttel.ru/shop/ip-telefony/ip-telefon-audiocodes-420hd