Audio Envoy, User Manual, Page: 36 / 70

HX iR Hand-Held
Transmitter
88
36
Setting the low frequency cut filter
The LF cut filter gives an approximately 10dB cut at 50Hz
to reduce handling and wind noise.
To check the status of the low frequency cut filter:
• Press MENU
• Press
a
twice until the
display shows:
Tx
LF Cut
• Align the front of the Switch iR with the infra-red port
on the transmitter and press OK .
The current LF cut filter setting
is displayed; for example:
Tx
OFF
To change the filter setting:
• Press OK again.
The current setting will flash.
• Press
a
or
v
to toggle between ON or OFF until the
required setting is displayed.
• Align the front of the Switch
iR
with the infra-red port
on the transmitter and press OK .
If the command was received successfully the new
setting will be displayed.
For example:
Tx
On
§ 5 HXir 12/10/01, 3:19 pm 36