drm141 Digital Receiver Module
Controls & Functions
Unlike a typical wireless system that uses a separate receiver for each channel, the SpectraPulse
™
UWB Wireless Microphone System uses a single Digital Receiver Module for 14 channels. The
drm141 functions as both the UWB receiver and antenna. It consists of three basic assembly
components that can be used for different mounting requirements: the main assembly, the front
bezel, and the plastic rear housing.
Note: The drm141 must be located in the same room in which the system will be operating.
The main assembly consists of a white antenna plate and a metal-shielded back box that houses
electronics.
Note: Do not disassemble the main assembly.
Doing so may void your warranty
and possibly void the authority to operate the unit.
This component “snaps” on to the front of the antenna plate, providing a finished appearance; it
fits with either the Plastic Rear Housing or installations into electrical boxes. (See
Mounting in the
Supplied Plastic Rear Housing
, or
Mounting to a 3-Gang Electrical Box
, page 9.)
This housing is provided for use in applications where the antenna unit cannot be installed directly
into a standard 3-gang electrical box. The housing provides key-hole slots on the back for mounting
on a wall, or the unit may be placed on a flat surface. The main assembly is mounted directly to
this housing with 6 screws. (See
Mounting in the supplied plastic rear housing
, page 9.)
drm141 assembled as shipped
Main Assembly
Front Bezel
Plastic Rear Housing
8
(contined on page 9)
1
2
1
2
3
4
(rear view)
3
4
