10
Rev.1.25
Blinking
(500 milliseconds interval lights): Charge Error. Likely indicating that the temperature of
the battery may be out of the acceptable range. Confirm that the temperature is within the
acceptable range.
OFF:
Microphone is off, not connected to a charger or no battery installed.
[8]
[DC IN] DC input terminal (side)
Used to connect the charger for charging the battery installed in the microphone.
[9]
[REC] button
Pressing this button will activate E1 output. (A signal is sent from the E1 contact of a receiver.)
[10]
[PWR/MUTE] button
Pressing this button will turn the microphone power [ON / OFF]. To turn "ON", press it for 1 second
or more, to turn "OFF", press it for 2 seconds or more.
While the power is on, pressing this button short once will mute the microphone, and pressing this
button again will cancel muting.
[11] [
SELECT] button
Selects the target for volume control.
Each time the button is pressed, the selection indicator changes as follows:
OWN [3] -> OTHER [4] -> LINE [5] -> OWN [3].
[12]
[BATT] Battery indicator
Indicates the status of the microphone power supply and the battery condition as follows:
Green light:
Power is turned "ON".
Yellow light:
Power is turned “ON”, but battery is low.
Red light:
Battery is depleted. Charge the battery.
Light off:
Power is turned "OFF".
Blinking (green or orange):
Pairing is in progress.
Blinking (green):
Under connection to Receiver*1 or Voice disconnected state.
(*1 When connecting two microphones to a receiver and am going to connect the third unit
microphone, it occurs.)
Blinking (yellow):
Out of range.
Blinking (red):
A pairing registration error with a receiver.
(Refer to the Troubleshooting section
on page 24)
