Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
2.2
Hood - TT RS
⇒ “2.2.1 Hood“, page 38
⇒ “2.2.2 Hood Hinge“, page 39
⇒ “2.2.3 Striker Pin with Catch“, page 39
⇒ “2.2.4 Left and Right Striker Pins“, page 40
⇒ “2.2.5 Impact Guard“, page 40
⇒ “2.2.6 Gas-Filled Strut“, page 40
⇒ “2.2.7 Center Hood Lock“, page 42
⇒ “2.2.8 Left and Right Hood Lock“, page 43
⇒ “2.2.9 Release Lever Mounting Bracket“, page 43
⇒ “2.2.10 Center Hood Lock Control Cable“, page 44
⇒ “2.2.11 Left Hood Lock Control Cable“, page 46
⇒ “2.2.12 Right Hood Lock Control Cable“, page 46
⇒ “2.2.13 Hood Lock Control Cable Mount“, page 47
2.2.1
Hood
Removing
– Remove the spray nozzles ⇒ Electrical Equipment; Rep. Gr.
92 ; Removal and Installation .
– Pull sealing plug -2- out of the hood.
– Guide electrical wiring harness -3- and washer fluid line -1- out
of the hood.
WARNING
Risk of injury!
♦ A second person is needed during removal and installa‐
tion to support and hold the hood.
– Loosen the left and right nuts -arrows- on the hinge.
– Remove hood -4-.
Installation
• For the correct tightening specifications, refer to
⇒ “1.2.1 Hood Assembly Overview“, page 12
Install in reverse order of removal. Note the following:
– Adjust the hood. Refer to
⇒ “1.2.3 Hood, Adjusting“, page 14
Audi TT 2007 ➤
Body Exterior - Edition 11.2010
38
Rep. Gr.55 - Hood, Lids
