Audi A5 Sportback (8T) 2010
No. 122, Body, Edition 8.09
4 Installing/removing roof bars on vehicle
6
10
2. Slide the roof bar half way back on the claw fastener -12-.
Once this procedure is complete, the positioning bolt -X-
must be aligned so that it sits centrally between the
starting position and the stop.
3. Remove the assembly tool.
4. Perform the identical procedure on the other side of the
vehicle.
–
Align the roof bar on the side — note the position on the
roof edge -arrow-.
The gap -a- must not exceed 1mm.
If the rubber supports on the support bracket housing are not
flush to the surface, we recommend that you have the width
adjustment checked by a qualified workshop
the roof bar width” on page 12
. Remove the roof bars before
doing so.
–
Gently tighten the bolts -13- alternately using the torque
wrench -15-.
–
Check the position of the support base housing -A- and
claw fastener -B- and correct if necessary.
–
Tighten one tensioning bolt -13- after another using the
torque wrench -15- until the torque wrench makes an
audible clicking sound. This indicates that the correct
torque has been applied.
–
Close the cover flap -16- and close the lock -17- with the
key -18-.
–
Follow the same procedure to install the second roof bar.
X
12
ZUB-0407
ZUB-0345
A
B
C
ZUB-0336
A
B
C
a
a
12
ZUB-0337
A
B
15
16
13
15
