Audi 100 Quattro, Owner'S Manual

Page: 21 / 180

CONTROLS AND EQUIPMENT
19
§
Insert belt tongue into buckle on
inboard side of seat. Push down until it is
securely locked with an audible click. Pull
belt to check.
§
Pull upwards on shoulder section to
make sure belt fits snugly across the
pelvis.
§
The shoulder belt must be posi-
tioned over the shoulder – it must never
rest against the neck . See illustration.
§
Belts should fit snugly across the
pelvis and chest. Make sure any slack
is wound up on the retractor.
§
Adjust height of belt anchorage, if
necessary. Do not wear shoulder part of
belt under your arm or otherwise out of
position. This would increase the
possibility of serious injury in case of an
accident.
§
To unfasten belt, push in release
button on buckle, Belt will spring out of
buckle.
§
To release a locked belt, lean back
to take the body pressure off the belt,
§
To store lap-shoulder belt, allow belt
to wind upon retractor as you guide belt
tongue to its stowed position.
Always heed WARNINGS on page 15
Lap belt
The lap belt for the rear center seating
position is equipped with a retractor.
The automatic retractor will lock the lap
belt when your passenger has buckled
up, and the remaining slack has been
retracted.
Make sure any slack is
wound on the retractor.
The belt can only be pulled out after it
is fully retracted.
§
To fasten lap belt grasp belt tongue
on outboard side of seat and slowly and
evenly pull across the pelvis. Insert belt
tongue into the respective buckle and
push down until it is securely locked with
an audible click. Pull belt to check.