11
Rear Panel overview
Rear panel description
AC Power inlet with fuse:
The mains power supply (100~240 V AC / 50~60 Hz) has to be applied to this AC power
inlet. The connection is made by an IEC C14 power connector and is fitted with a fuse. When
replacing the fuse, make sure that the value of the replacement fuse matches the value of
the original fuse. (T1AL/250V)
RS232 Connection:
The RS232 connection can be used to control the system and its installed modules through
any external hardware such as home and industrial automation systems. The pinout and
communication settings are described in an earlier chapter of this user manual. The complete
RS232 command instruction set and configuration information can be downloaded from the
AUDAC website.
Ethernet RJ45 Connector:
The connection to any LAN network is possible using the RJ45 ethernet connection. This
allows control of the system and its installed modules from any ethernet supported device.
Various possibilities of ethernet control are available, including sending commands over TCP/
IP, controlling the system through the integrated web-interface, or full system control using
the Audac Touch™ application.
For more information about the Ethernet configuration of this device, check ‘Chapter 4: User
interface & Configuration’ and ‘Chapter 6: IP Basics’ of this user manual.
SourceCon™ interface card slots:
Four modular slots are available on the rear panel of the unit, allowing installation for a wide
variation of optional SourceCon™ modules depending of the required system functionality.
The module slots are fitted with a guiding system and connections are made by board-
edge connectors allowing fast and simple installation. Once installed, functionalities are
automatically discovered at startup and made operational by the device software.
