AUDAC Multi-functional SourceCon MFA208, User Manual

Page: 26 / 32

26
Chapter 5
Installing the SourceCon
™
module
CAUTION
Before installing any modules to the expansion slot of the MFA, make sure the AC mains power is
disconnected. Malfunctions or electrical shocks may occur otherwise.
Step 1:
Make sure that the slot where the module shall be installed is open and ready for installation. In standard (factory
default) configuration, the MFA comes delivered with the slot covered by a blind panel. The blind panel should be
removed by releasing the screws on both ends.
Step 2:
Before removing the modules from their protective bag, we recommend touching the grounded metal chassis of the
MFA (or any other grounded point) to prevent electrostatic discharges affecting the sensitive electronic components.
It is recommended to always hold the module card by the metal panel and avoid touching of the components on
the circuit board directly.
Step 3:
Align both edges of the module with the guide rails inside the slot and carefully insert the module into the slot. It
should slide into the slot without any considerable resistance when well positioned into the guide rail.