AUDAC DPA152, User Manual & Installation Manual

Page: 8 / 31

7
Rear panel overview
Description
4. Power inlet:
The mains power supply (110~240V AC / 50~60 Hz) has to be applied to this AC power inlet.
The connection is made by an IEC power connector and is fitted with a fuse. When replacing the
fuse, make sure that the value of the replacement fuse matches the value of the original fuse.
(T4AL/250V for DPA 152 & T6H/250V for DPA252)
5. Loudspeaker connections:
The loudspeaker connections are performed in two different ways. Every channel has Speakon and
euro terminal block output connections. In this way, the connections can be always made on the
most simple way for every application.
A detailed description about the best method for connecting the loudspeakers for every application
can be found in the next chapter, connecting the amplifier.
6. Input connections:
The input connections of the amplifier are performed using balanced XLR connectors. Every
channel has an XLR input connector and a XLR link output connector. The input signal from the
signal source, pre-amplifier or mixer should be connected to the XLR input connections. And by
means of the XLR link output connectors, the signal can be linked through to multiple amplifiers.
7. Operation mode switch:
By means of this switch, the operation mode of the amplifier can be selected between standard
stereo mode, parallel mode and bridge mode. For standard stereo applications, this switch should
be turned to center position for “Stereo” mode.
4. AC power inlet with fuse
5. Loudspeaker connections 7. Operation mode switch:
6. Input connections