AUDAC DPA152, User Manual & Installation Manual

Page: 10 / 31

9
2) Bridge mono Mode:
In bridged mono mode, the power of both output channels is merged to deliver
double the power to one single 8 Ohm load. The mode selection switch should be
positioned in the Bridge position (Left position of the switch).
The output of the signal source should only be connected with the Channel 1 XLR
input connector of the amplifier.
For more information about how the loudspeakers should be connected in bridge
mode, refer to the “Output Connections” section of this user manual.
3) Parallel Mode:
In parallel mode (Right position of the switch), the amplifier is configured in a way
that only the signal applied to the XLR input connector of Channel 1 will be used,
and will be amplified by both output channels.
The output level of both channels can be individually controlled by means of the
rotary controls on front of the amplifier.