AUDAC AMP523, User Manual

Page: 22 / 32

22
Configuration >> Wall panel Settings
In this window, the wall panel address settings for the MWX43/45 wall panels can be
made.
Wall panel settings screen for AMP523/RM523
The address is always set correct for new delivered wall panels. When the connected
wallpanel has been used in another application, it can be configured to another
address. To avoid problems in all circumstances, it is recommended to always run
through the AMP523/RM523 wall panel address configuration procedure. This is very
simple and described below.
Set Address AMP523
Just connect the MWX43/45 wall panel to the “RS485 + AUDIO” RJ45 input on the
AMP523/RM523. After this is done, the “Set Address” button should be pressed in
the “Wallpanel Settings” menu. The message “Push the upper button on the wall
panel to confirm the address” will appear and the LED’s on the MWX43/45 wall panel
will start to blink. After the upper button on the wall panel is pressed, the correct
address will be assigned and the message will disappear. Now the wall panel is ready
for operation.