AUBER INSTRUMENTS
WWW.AUBERINS.COM
2018.08
P11/14
reached a timer event. It will continue this beeping pattern until the time
duration programmed by parameter Ad has been reached.
2)
Three 1s short beeps (―●―●―): It indicates
first event timer has started.
The reading temperature has reached timer starting set point, btSP.
3)
Eight 5s long beeps (――――― ●●――――― ●●―――――
●● ――――― ●● ――――― ●● ――――― ●● ―――――
●● ―――――): It indicates the whole program has ended. Both display will
flash “end”.
10. Common sensor errors:
This regulator will display error message or incorrect temperature reading if your
sensor is not connected, or your sensor is bad. Top display will flash
“orAL”
and
“
932
”
alternately, if you set it to Fahrenheit display (C-F =
°
F
); or “orAL” and “500”
alternately, if you set it to Celsius display (C-F =
°
C).
Auber Instruments
5755 North Point Parkway, Suite 99
Alpharetta, GA 30022
www.auberins.com
Email: [email protected] Tel: 770-569-8420
Copyright 2007-2018, Auber Instruments All Rights Reserved.
No part of this manual shall be copied, reproduced, or transmitted in any way
without the prior, written consent of Auber Instruments. Auber Instruments
retains the exclusive rights to all information included in this document.
