User’s Manual
24
NOTE: You will need to get the appropriate IP Address, Gateway and Subnet Mask from your network administrator.
Highlight the box beside
DNS Server
. Press the
Up
and
Down
arrow buttons to set the IP address of the DNS server.
Highlight
Use UPnP
and press the button to toggle between On and Off. When it is On, port forwarding from the
NAT (Network Address Translation) device to the DVR will be enabled automatically via UPnP (Universal Plug and
Play) service. This function will be especially useful when accessing a port on a private IP address.
NOTE: For the UPnP service to work, the NAT device should support the UPnP Port Forwarding function and
the function should be set to enabled.
You cannot change the port settings when Use UPnP is On.
Highlight the
Status
box and press the button to display the port numbers forwarded from the NAT device via UPnP
service.
Highlight the
Port Number Setup…
box and press the button. The
Port Number Setup
screen appears.
NOTE: You will need to get the appropriate Port Numbers for each ATVision related program (Admin, Callback,
Watch, Search and Audio) from your network administrator.
Change the numbers by highlighting them and using the
Up
and
Down
arrow
buttons to increase or decrease the number. The factory default Port settings are:
Remote
Admin:
8200
Remote
Callback: 8201
Remote Watch:
8016
Remote
Search:
10019
Remote
Audio:
8116
NOTE: Do NOT use the same port number for two different programs, otherwise, the DVR cannot be connected
with the PC running ATVision.
CAUTION: When changing the port settings, you must change the port settings on the PC running
ATVision as well. Refer to the ATVision manual for details.
Selecting
DHCP
from the Type and highlighting
Save
button
reads the current IP address of the DVR configured by DHCP
(Dynamic Host Configuration Protocol) network.
Highlight
Auto
(Default) and press the button to toggle
between On and Off. When it is On, the DVR will obtain the
IP address of the DNS server automatically.
NOTE:
Selecting Auto will only be enabled when the DVR
is configured for DHCP or an ADSL network.
Selecting
ADSL (with PPPoE)
allows you to set up the ADSL
network.
Highlight the box beside
ID
and press the button. A
virtual keyboard appears allowing you to enter the ID for
ADSL connection.
Highlight the box beside
Password
and press the button.
A virtual keyboard appears allowing you to enter the password
for ADSL connection.
NOTE:
Entering the ID and Password and highlighting OK
reads the current IP address of the DVR configured
by the ADSL network.
NOTE: If the DVR is configured for DHCP or an ADSL network, the IP address of the DVR might change whenever
the unit is turned on.
Summary of Contents for VLDVR Series
Page 1: ......
Page 9: ...User s Manual 2 Figure 1 Typical DVR installation...
