31 |
P a g e
Time
00:00:00
set time 03:32:30
TimeZone
EST
set timezone pst
Uptime
get uptime
Username
root
set username Barbara
VerboseMode
enabled
set verbosemode disabled
Command explanations
AutoMap
Automap will automatically map a subset of target devices visible
to the firmware to a set of Fibre Channel LUNs. All previous maps
will be deleted.
AutoMap
Requires a SaveConfiguration command
BootFibreDelay
BootFibreDelay sets the delay (in seconds) after startup before
enabling the Fibre Channel ports. The value "0" constitutes no
delay.
Default: 0 (no delay)
set BootFibreDelay [0-255]
Requires a SaveConfiguration command
get BootFibreDelay
ClearCliLog (Immediate, Supported In-Band)
Clears the contents of the CLI command log.
Usage: ClearCliLog
ClearEventLog
ClearEventLog clears the contents of the event log.
ClearEventLog
ControllerLun (OEM Configurable, Disabled on Error)
ControllerLun controls the automatic generation of a controller
device at LUN 0. After enabling or disabling the controller LUN,
save configuration and run automap to re-map all devices.
set ControllerLun [enabled | disabled]
get ControllerLun
ControllerModel
ControllerModel reports the specific model and firmware
information to the CLI.
get ControllerModel
ControllerName (OEM Configurable, Disabled on Error)
ControllerName provides a descriptive ASCII name assigned to
the unit. This field is used by applications to identify individual
units. The specified name can be up to a maximum of 32
characters. If the name contains spaces, it must be enclosed in
quotation marks. Unlike other non-immediates, changes to
ControllerName take
effect immediately.
set ControllerName [name]
get ControllerName
CoreDumpInfo
Displays information concerning a core dump stored by a prior
fault.
CoreDumpInfo
DataMoverStats
Displays statistics on aggregate data copied by the Data Mover.
Shows the previous hour and minute. Use "all" to display
statistics over the entire 24 hour period.
Usage: get DataMoverStats [all]
